skip to main text

Front View

(1) top cover
Open to replace an ink tank or remove jammed paper inside the printer.
(2) feed slot cover

Prevents anything from falling into the feed slot.

Open it to slide the paper guides, and close it before printing.

(3) paper support
Open to load paper in the rear tray.
(4) rear tray

Two or more sheets of the same size and type of paper can be loaded at the same time, and fed automatically one sheet at a time.

(5) paper guides
Align with both sides of the paper stack.
(6) disc tray guide
Attach the disc tray here. Use when printing onto a printable disc. Keep closed for normal operation.
(7) paper output tray
Printed paper is ejected. Open it before printing.
(8) output tray extension
Pull out to support ejected paper.
  • * All buttons and lamps are shown lit in the above figure for explanatory purposes.
(9) POWER lamp
Lights after flashing when the power is turned on.

Note

  • You can check the status of the printer by the POWER and Alarm lamps.

    • POWER lamp is off: The power is off.
    • POWER lamp lights: The printer is ready to print.
    • POWER lamp flashes: The printer is getting ready to print, or printing is in progress.
    • Alarm lamp flashes: An error has occurred and the printer is not ready to print.
    • POWER lamp flashes and Alarm lamp flashes alternately: An error that requires contacting the service center may have occurred.
(10) ON button

Turns the power on or off.

(11) Alarm lamp
Lights or flashes when an error occurs.
(12) RESUME/CANCEL button
Cancels a print job in progress. You can press this button to release from printer error status and resume printing, after the printer problem is resolved.
(13) Wi-Fi button/Wi-Fi lamp

Hold down to automatically set up the wireless LAN connection.

Lights or flashes to indicate the wireless LAN status.

Lights:
Wireless LAN connection is enabled.
Flashes:
Printing over wireless LAN. Also flashes while configuring the wireless LAN connection.
(14) direct print port

Connect a PictBridge compliant device such as a digital camera to print directly.

Warning

  • Do not connect any equipment other than PictBridge compliant devices to the direct print port of the printer. This may cause fire, electric shock, or damage to the printer.

Important

  • Do not touch the metal casing.
  • Do not use the USB cable longer than 10 feet (3 meters) to connect any PictBridge compliant device to the printer since it may affect the operation of other peripheral devices.
(15) disc tray storage compartment

The disc tray supplied with the printer can be stored here.